How To Darken Your Tail Lights
If you are interested in modding your vehicle, tinting your tail lights can be one of the easiest and most effective mods for the amount of time and money spent. I have completed this mod on my 2009 Chevy HHR and it turned out GREAT! There are a few important steps to follow tiffany blue nikes, so please read all of the steps completely before you begin this mod beats by dre.
First off, you need to decide which lights you are going to tint. I have tinted the side marker lights ergo baby carrier, rear reflectors vanessa bruno, and tail lights vanessa bruno. You will need some fine grain sand paper, starting at 600 grit clarisonic mia, up to 2000 grit. Get atleast 3 different sizes hermes belt, the more the better. You will also need a can of VHT Night Shades tinting paint. This is available at most auto parts stores in a spray can, and is very cheap vivienne westwood, usually under %15 for the can chan luu. You will also want a can of spray on clear coat, to seal the lights you spray.
Once you have your supplies, you can either remove the lights your are spraying from the vehicle, or mask off the entire area around each of the lights you want to tint. On my Chevy HHR I removed the rear side markers and tail lights, and masked off the rear reflectors and front side markers. You do not want any overspray on your paint so mask as much as you can hermes bracelet!
First you need to sand down the lenses. Start with the roughest grit, and wet sand down until you get to the 2000 grit. Lightly sand only, as you are basically trying to create a good surface for the tint to adhere to, while removing wax and any coating on your lenses.
Now that your sanding is complete, completely clean the lenses with rubbing alcohol and let them dry vivienne westwood. Make sure there are no fibers or stray material on them, this is crucial ティファニー! Grab your can of VHT Night Shades and apply your first light coat. After this initial coat dries, re-apply this step until you reach the darkness you prefer. If tinting your headlights (This may be illegal in some states and provinces), I would never go more than one or two very light coats. Once you are completed tinting, you can apply up to three coats of clearcoat. This will help protect the lense lululemon, and ensure that the tint you have applied will not wear off.
Now vanessa bruno, after your tinting and clearcoating has finished drying, you can either re-install the lights or unmask the area around your tinted lights. Take your vehicle for a drive and enjoy your easy mod. I had the lights on my Chevy HHR tinted all in a saturday afternoon. Just make sure you complete your prep work the proper way, and your end result will look great vanessa bruno!

microsoft office 2007 product key the season to be pissed off

vivienne westwood Who are the best men bespoke tailors in Los Angeles

vanessa bruno Review Of Snowboarding Jackets

ヴィトン 財布 Protection and elegance

clarisonic mia Hopewell Valley High's Wagner sets Mercer County Freshman